BRP Can-Am Outlander 2015 Series Manual page 429

Using a
FLUKE 115 MULTIMETER (P/N 529 035 868)
check resistance value between terminals as fol-
lows.
INJECTOR
GROUND CIRCUIT
CYLINDER
WIRE
ADAPTER
FRONT BK/RD
BR/BU
REAR
If continuity is not good, repair or replace wiring
going to injector.
If continuity is good, replace the injector.
Fuel Injector Removal
To remove the injector, first remove the fuel rail.
FUEL RAIL
Refer to .
vmr2009-022-001_a
TYPICAL - FUEL RAIL ASS'Y
1. Fuel rail
2. Fuel injector
3. Injector top O-ring
4. Injector bottom O-ring
5. Manifold O-ring
Then, pull fuel injector out of the fuel rail.
Fuel Injector Installation
For the installation, reverse the removal proce-
dure. Pay attention to the following details.
FUEL INJECTOR IDENTIFICATION
ENGINE INJECTOR COLOR CODE
800R
1000
Apply a thin film of engine oil to O-rings to ease
insertion in rail.
Install fuel injector with your hand. Do not use any
tool.
vmr2013-027
Subsection XX (ELECTRONIC FUEL INJECTION (EFI))
MEASUREMENT
ECM
K4
Close to 0
L4
RED
GREEN
,
FUEL INJECTOR INSTALLATION
O-RINGS New
Position the manifold O-ring on injector as in fol-
lowing illustration.
vmr2006-014-071_a
TYPICAL - MANIFOLD O-RING POSITION
Carefully insert injector in manifold paying atten-
tion to the manifold O-ring.
NOTICE
Gently push O-ring in evenly all
around while inserting injector. O-ring must
be completely inserted and not visible, before
completing the insertion of the injector.
vmr2006-014-072_a
Firmly push injector until it bottoms out.
Reinstall fuel rail.
Lubricate with engine oil
11