Engine (Lubrication System) - BRP Can-Am Outlander 2015 Series Manual

vmr2012-0005-051_a
TYPICAL — ALL MODELS
1. Screws
2. Tail pipe
3. Remove exhaust tail pipe, gasket (discard) and
spark arrester.
tmo2011-001-041_a
1. Spark arrester
2. Gasket
3. Exhaust tail pipe
4. Remove carbon deposits from the spark ar-
rester using a brush.
NOTICE
Use a soft brush and be careful to
avoid damaging spark arrester mesh.
vmr2012-005
Subsection XX (PERIODIC MAINTENANCE PROCEDURES)
tmo2011-001-043_a
1. Clean spark arrester
5. Inspect mesh of spark arrester for any damage.
Replace as required.
6. Inspect spark arrester chamber in muffler.
Clean as required.
For installation, reverse the removal procedure.
However pay attention to the following.
Install new gasket and new retaining screws.
Tightening Torque

ENGINE (LUBRICATION SYSTEM)

Recommended Engine Oil
SEASON
Summer
If recommended XPS oil is not available, use a
4-stroke SAE 5W 40 engine oil that meets or ex-
ceeds the requirements for API service classifica-
tion SG, SH or SJ. Always check the API service
label certification on the oil container, it must con-
tain at least one of the above standards.
Engine Oil Level Verification
NOTICE
proper level may severely damage engine.
NOTE: While checking the oil level, visually in-
spect engine area for leaks.
TAIL PIPE RETAINING SCREWS
(97 lbf•in ± 9 lbf•in)
RECOMMENDED ENGINE OIL
XPS 4-STROKE SYNTH.
BLEND OIL (SUMMER)
(P/N 293 600 121)
XPS 4-STROKE SYNTHETIC OIL
Winter
(ALL CLIMATE) (P/N 293 600 112)
Operating the engine with an im-
11 N•m ± 1 N•m
TYPE
5