BRP Can-Am Outlander 2015 Series Manual page 526

tmr2011-030-014_a
TYPICAL
1. Reset Service button
Clock Setting Using Gauge Selector
Button
To set current time, proceed as follows:
1. Select the clock display.
vmo2012-012-029_o
1. Time (Display 2)
2. Message (Display 3)
vmo2011-008-001_a
RENEGADE GAUGE
1. Selector button
2. Time
2. Press and HOLD selector button.
vmr2013-035
Subsection XX (LIGHTS, GAUGE AND ACCESSORIES)
Outlander Models
NOTE: SET TIME will appear on display 3.
Renegade Models
NOTE: The display will flash.
Outlander and Renegade Models
3. Choose the 12-hour (12H) or 24-hour (24H) for-
mat by pressing button.
4. If the 12-hour format was selected, choose Am
(A) or Pm (P) by pressing button.
5. Press and HOLD button.
6. Choose hour first digit by pressing button.
7. Press and HOLD button.
8. Choose hour second digit by pressing button.
9. Press and HOLD button.
10. Choose minutes first digit by pressing button.
11. Press and HOLD button.
12. Choose minutes second digit by pressing but-
ton.
13. Press button to enter settings (CLOCK will ap-
pear on display).
NOTE: The gauge will display the current time for
10 seconds then will return to the normal display
mode.
Multifunction Gauge Set-Up Using
B.U.D.S.
Connect to the applicable B.U.D.S. software. Re-
fer to COMMUNICATION TOOLS AND B.U.D.S.
subsection.
Language Selection
In B.U.D.S., select the:
– Setting page tab
– Cluster page tab.
Scroll and select the desired display language in
the Cluster Language box.
vmr2013-035-001_a
TYPICAL
1. Cluster Language box
13