BRP Can-Am Outlander 2015 Series Manual page 770

PROCEDURES
PLASTIC RIVET
Plastic rivets are used in the riveting of the vari-
ous body parts. Plastic rivets can be reused many
times. Use the
OETIKER PLIERS (P/N 295 000 070)
to remove them.
V06L08A
TYPICAL
1. Pliers
2. Plastic rivet
DECALS
Decal Removal
Using a heat gun warm up one end of decal for a
few seconds until decal can roll off when rubbing
with your finger.
Pull decal slowly and when necessary apply more
heat to ease removal on the area that has to be
peeled off.
If decal tears while pulling off, it has to be heated
for a few seconds longer. If decal tends to stretch
while pulling off, stop heating and wait a few sec-
onds to let it cool, then peel it off.
Decal Installation
Using isopropyl alcohol, clean the surface and dry
thoroughly.
Apply liquid soap to new decal and carefully posi-
tion it. Using a sponge or a squeegee, remove the
air bubbles and surplus water working from the
center toward the edges. Allow to air dry.
NOTICE
Do not apply isopropyl alcohol or
solvent directly on decals. Use these products
in a well ventilated area.
vmr2013-046
2 1
Subsection XX (BODY (RENEGADE))
FRONT BODY MODULE
Front Body Module Removal
CONSOLE
1. Remove . See procedure in this sub-
section.
GAUGE SUPPORT
2. Remove
GAUGE AND ACCESSORIES
3. Remove SIDE PANELS
subsection.
INNER FENDER PANELS
4. Remove
dure in this subsection.
5. Disconnect headlights connectors (on both
sides).
vmr2012-047-001_a
RH SIDE SHOWN
1. Headlight connectors
6. Disconnect 12-volt power outlet connector.
vmr2012-047-002_a
FROM UNDERNEATH RH FRONT FENDER
1. 12-volt power outlet connector
7. Disconnect ignition switch connector.
LIGHTS,
. Refer to
subsection.
. See procedure in this
. See proce-
7