BRP Can-Am Outlander 2015 Series Manual page 503

Subsection XX (CHARGING SYSTEM)
vmr2012-032-002_a
TYPICAL
1. Battery retaining plate
2. Retaining plate screws (3)
4. Remove battery.
Battery Cleaning
Clean the battery support, cables and battery
posts using a solution of baking soda and water.
Remove corrosion (if so) from battery cable ter-
minals and battery posts using a firm wire brush.
Rinse with clear water and dry well.
Battery Storage
If the battery is in storage or used infrequently,
disconnect the battery cables to eliminate drain
from electrical equipment.
For extended storage, remove the battery from
vehicle.
Clean battery terminals and cable connections us-
ing a wire brush. Apply a light coat of
GREASE (P/N 293 550 004)
Clean battery casing using a solution of baking
soda and water. Rinse battery with clear water
and dry well using a clean cloth.
Regularly charge battery as per manufacturer's
recommendations.
For other recommendations during storage, refer
to battery manufacturer's instructions.
WARNING
Ensure to store battery in a safe place, out of
reach for children.
Battery Installation
NOTICE
Always connect RED (+) cable first
then BLACK (-) cable.
Installation is the reverse of removal procedure,
however pay attention to the following.
4
DIELECTRIC
on terminals.
TIGHTENING TORQUE
Battery retaining plate
screws
4 N•m to 5 N•m
(35 lbf•in to 44 lbf•in)
vmr2013-032