BRP Can-Am Outlander 2015 Series Manual page 613

vmr2012-039-018_a
A. XPS synthetic grease (P/N 293 550 010) here
5. Insert the steering column onto the DPS input
shaft
6. Position the LH DPS support bracket onto the
hexagonal forming screw that was left on the
frame DPS mount.
vmr2012-039-019_a
1. Steering column onto the DPS input shaft here
2. LH DPS support bracket onto the hexagonal forming screw here
NOTE: The DPS shaft splines have a key which
must be aligned with the keyway in the steering
column.
vmr2013-040
Subsection XX (DYNAMIC POWER STEERING (DPS))
vmr2010-003-031
TYPICAL - STEERING COLUMN INDEXED TO DPS SHAFT
SPLINES
7. Ensure the following are properly positioned
on the lower steering shaft and lower steering
shaft mount.
– O-rings
– Steering shaft half bushings.
vmr2012-039-020_a
1. Lower steering shaft mount
2. O-rings
3. Steering shaft half bushings
8. Install the 3 remaining hexagonal forming
screws that secure the DPS unit loosely using
NEW fasteners.
NOTE: Ensure the support bracket retaining
screws have a NEW conical spring washer be-
tween the screw head and the DPS frame sup-
port.
Ensure both tie rod ends have a hardened steel
washer on them, then insert the tie-rod ends onto
the pitman arm.
19