BRP Can-Am Outlander 2015 Series Manual page 386

Subsection XX (DIAGNOSTIC SYSTEM AND FAULT CODES)
C21E1 SCM
C21F0 SCM
C21F3 SCM
C21F4 SCM
P0030
ECM
P0031 ECM
2
Air Leak Plausibility
check Rear suspension
Pressure threshold not
reach Front suspension (threshold change in function
adjustment
Air Leak Plausibility
check Front Right
suspension
Air Leak Plausibility
check Front left
suspension
Internal fault path
number for Signal
error : power stage
of heater of Sensor
upstream catalyst
Internal fault path
number for Min error :
power stage of heater
of Sensor upstream
catalyst
If maximum number of
readjustment for rear
suspension is reach
If pressure threshold
not reach after
calibrated time delay
of compressor temperature)
(When front suspension
adjustment activated)
If maximum number of
readjustment for front right
suspension is reach
If maximum number of
readjustment for front left
suspension is reach
Damaged O2 sensor,
damaged circuit wires,
damaged connector or
damaged ECM output pins.
Damaged O2 sensor,
damaged circuit wires,
damaged connector or
damaged ECM output pins.
Open SCM Activation page in
BUDS, performe a combined
test in System self test
sequence section
Open SCM Activation page in
BUDS, performe a combined
test in System self test
sequence section
Open SCM Activation page in
BUDS, performe a combined
test in System self test
sequence section
Open SCM Activation page in
BUDS, performe a combined
test in System self test
sequence section
Check fuse.
Disconnect HO2S1.
Measure voltage between
harness connector HO2S1-C
and ground (expected
value = 11 to 13 volts).
Measure resistance between
HO2S1 pin C and D (expected
value = 7 to 12 ohms).
Disconnect ECM-B.
Measure resistance
between harness connector
HO2S1-D and ground
(expected value > open).
Measure resistance
from harness connector:
HO2S1-D to ECMB-L2
(expected value: < 2 ohms).
Check fuse.
Disconnect HO2S1.
Measure voltage between
harness connector HO2S1-C
and ground (expected
value = 11 to 13 volts).
Measure resistance between
HO2S1 pin C and D (expected
value = 7 to 12 ohms).
Disconnect ECM-B.
Measure resistance
between harness connector
HO2S1-D and ground
(expected value > open).
Measure resistance
from harness connector:
HO2S1-D to ECMB-L2
(expected value: < 2 ohms).
tmr2013-025