BRP Can-Am Outlander 2015 Series Manual page 393

P0136 ECM
P0137 ECM
P0138
ECM
tmr2013-025
Subsection XX (DIAGNOSTIC SYSTEM AND FAULT CODES)
ECU int. fault path no.:
electrical diagnosis for
second lambda sensor
upstream cat. npl-error
ECU int. fault path no.:
electrical diagnosis
for second lambda
sensor upstream cat.
min-error
ECU int. fault path no.:
electrical diagnosis
for second lambda
sensor upstream cat.
max-error
Damaged O2 sensor,
damaged circuit wires,
damaged connector or
damaged ECM output pins.
Damaged O2 sensor,
damaged circuit wires,
damaged connector or
damaged ECM output pins.
Damaged O2 sensor,
damaged circuit wires,
damaged connector or
damaged ECM output pins.
Check fuse.
Disconnect HO2S2.
Measure voltage between
harness connector HO2S2-C
and ground (expected
value = 11 to 13 volts).
Measure resistance between
HO2S2 pin C and D (expected
value = 7 to 12 ohms).
Disconnect ECM-B.
Measure resistance
between harness connector
HO2S2-D and ground
(expected value > open).
Measure resistance
from harness connector:
HO2S2-D to ECMB-L3
(expected value: < 2 ohms).
Check fuse.
Disconnect HO2S2.
Measure voltage between
harness connector HO2S2-C
and ground (expected
value = 11 to 13 volts).
Measure resistance between
HO2S2 pin C and D (expected
value = 7 to 12 ohms).
Disconnect ECM-B.
Measure resistance
between harness connector
HO2S2-D and ground
(expected value > open).
Measure resistance
from harness connector:
HO2S2-D to ECMB-L3
(expected value: < 2 ohms).
Check fuse.
Disconnect HO2S2.
Measure voltage between
harness connector HO2S2-C
and ground (expected
value = 11 to 13 volts).
Measure resistance between
HO2S2 pin C and D (expected
value = 7 to 12 ohms).
Disconnect ECM-B.
Measure resistance
between harness connector
HO2S2-D and ground
(expected value > open).
Measure resistance
from harness connector:
HO2S2-D to ECMB-L3
(expected value: < 2 ohms).
9