BRP Can-Am Outlander 2015 Series Manual page 492

smr2010-050-022_a
Step 2: Insert GM terminal extractor tool (P/N 12094430)
3. Gently pull on the wire to extract the pin out the
back of the connector.
smr2010-050-023_a
Step 3: Pull wire to extract pin
NOTICE
Before installing terminals in the
connectors, ensure all terminals are properly
crimped on the wires. After installation of the
wire terminals in the connectors, ensure they
are properly locked by gently pushing on them
as if to extract them.
BATTERY AND STARTER CABLE
TERMINALS
Cable Crimping
Carefully strip the wire approximately to 10 mm
(3/8 in) in length, using a wire stripping tool or
sharp blade/knife.
vmr2013-030
Subsection XX (WIRING HARNESS AND CONNECTORS)
A32E2QA
A. 10 mm (3/8 in)
NOTE: Make sure not to cut wire strands while
stripping the wire.
Install the appropriate terminal on the wire ac-
cording to the requirement. Refer to appropriate
PARTS CATALOG
A32E2RA
INSTALLATION OF TERMINAL
Follow the instructions provided with the
ING TOOL (HEAVY GAUGE WIRE) (P/N 529 035 730)
to select the proper position of the tool.
529035730
NOTE: Different wires require different crimping
pliers settings.
A
.
CRIMP-
27