BRP Can-Am Outlander 2015 Series Manual page 383

Subsection XX (DIAGNOSTIC SYSTEM AND FAULT CODES)
FAULT REPORTING
CODE MODULE
U0155 ECM
U0155
ECM
U0167 ECM
26
DESCRIPTION
Missing CLUSTER
CAN ID.
Lost communication
Module internal error.
with CLUSTER Damaged circuit wires
or damaged module
pins.
Missing CAN ID.
Lost communication Module internal error.
with CLUSTER (lost of
Damaged circuit wires
CAN ID's) or damaged module
pins.
Lost communication The vehicle immobilizer
with vehicle is reporting an
immobilizer control electrical fault on the
module communication line.
POSSIBLE CAUSE
Measure voltage between harness
connector CL-17 and ground.
(Expected value = 11 to 13 volts).
Disconnect MPI2
from DLC connector.
Measure resistance between
DLC-1 and DLC-2. (Expected
value = 50 to 70 ohms).
Measure resistance between
DLC-1 and ECM-B1.
(Expected value < 2 ohms).
Measure resistance between
DLC-2 and ECM-C1.
(Expected value < 2 ohms).
Measure resistance
between DLC-1 and CL-19.
(Expected value < 2 ohms).
Measure resistance between
DLC-2 and CL-18. (Expected value
< 2 ohms).
Check for Cluster fault or ECM fault.
Measure voltage between harness
connector CL-17 and ground.
(Expected value = 11 to 13 volts).
Disconnect MPI2
from DLC connector.
Measure resistance between
DLC-1 and DLC-2. (Expected
value = 50 to 70 ohms).
Measure resistance between
DLC-1 and ECMB-C1.
(Expected value < 2 ohms).
Measure resistance between
DLC-2 and ECMB-C2.
(Expected value < 2 ohms).
Measure resistance
between DLC-1 and CL-19.
(Expected value < 2 ohms).
Measure resistance between
DLC-2 and CL-18. (Expected value
< 2 ohms).
Check for dirty or oxidized
Key contact. Clean
key contact if needed.
Check for broke key contact.
Ensure sensor connector
is fully inserted.
Measure resistance between
ECMB-A1 and CC-C.
(Expected value < 2 ohms).
Measure resistance between
ECMB-C2 and CC-E. (Expected
value < 2 ohms).
SERVICE ACTION
vmr2013-026