BRP Can-Am Outlander 2015 Series Manual page 407

P1130 ECM
P1136 ECM
P1171 ECM
P1172 ECM
P1174 ECM
P1175 ECM
P1339 ECM
tmr2013-025
Subsection XX (DIAGNOSTIC SYSTEM AND FAULT CODES)
ECU int. fault path no.:
electrical diagnosis
for lambda sensor
upstream cat. Sig-error
ECU int. fault path no.:
electrical diagnosis for
second lambda sensor
upstream cat. Sig-error
Diagnostic Fault code
for Fuel Supply System
(ORA Max Fault)
Diagnostic Fault code
for Fuel Supply System
(ORA Min Fault)
Diagnostic Fault code
for Fuel Supply System
(ORA Max Fault)
Exhaust Bank2
Diagnostic Fault code
for Fuel Supply System
(ORA Min Fault)
Exhaust Bank2
Signal fault at phase
determination
Damaged O2 sensor,
damaged circuit wires,
damaged connector or
damaged ECM output pins.
Damaged O2 sensor,
damaged circuit wires,
damaged connector or
damaged ECM output pins.
Injection and fuel supply
system.
Injection and fuel supply
system.
Injection and fuel supply
system.
Injection and fuel supply
system.
backup phase detection
strategies not able to find
the correct phase
Check fuse.
Disconnect HO2S1.
Measure voltage between
harness connector HO2S1-C
and ground (expected
value = 11 to 13 volts).
Measure resistance between
HO2S1 pin C and D (expected
value = 7 to 12 ohms).
Disconnect ECM-B.
Measure resistance
between harness connector
HO2S1-D and ground
(expected value > open).
Measure resistance
from harness connector:
HO2S1-D to ECMB-L2
(expected value: < 2 ohms).
Check fuse.
Disconnect HO2S2.
Measure voltage between
harness connector HO2S2-C
and ground (expected
value = 11 to 13 volts).
Measure resistance between
HO2S2 pin C and D (expected
value = 7 to 12 ohms).
Disconnect ECM-B.
Measure resistance
between harness connector
HO2S2-D and ground
(expected value > open).
Measure resistance from
harness connector: HO2S2-D
to ECMB-L3 (expected
value: < 2 ohms).
Check injector and fuel
supply system.
Check injector and fuel
supply system.
Check injector and fuel
supply system.
Check injector and fuel
supply system.
23