BRP Can-Am Outlander 2015 Series Manual page 276

vmr2007-051-003_a
1. Friction washer
2. Collar
3. One way clutch
Sliding Sheave
Install centrifugal levers with their thrust washers.
NOTICE
Centrifugal levers must move easily
after installation.
Governor Cup
Rebuild governor cup with new roller sleeves,
rollers and slider shoes.
NOTICE
Final position of roller sleeves must
be flush with the sleeve bore in the governor
cup arm (no protrusion).
vmr2006-021-029_a
1. Top edge of roller sleeve
2. Mating surface of slider shoes
3. Vice
Whenever replacing the roller sleeves, make a
mark in the box on the governor arm using a
punch.
NOTICE
Do not tap too hard. Severe damage
to the governor cup may appear.
vmr2013-059
Subsection 11 (CONTINUOUSLY VARIABLE TRANSMISSION (CVT))
vmr2006-021-017
NOTICE
Rollers must move easily after in-
stallation.
Carefully press slider shoes in the governor cup
arm so they bottom out evenly in the machined
portion of the governor cup arm.
NOTICE
Slider shoes must be pressed in
evenly to ensure they are centered in the arm
and slide properly in the guides.
Drive Pulley Installation
For installation, reverse the removal procedure.
Pay attention to the following details.
WARNING
Do not apply antiseize or any lubricant on
crankshaft and drive pulley tapers.
NOTICE
Never use any type of impact
wrench for drive pulley removal and instal-
lation.
Clean mounting surfaces as described in
PULLEY CLEANING .
Install drive pulley on crankshaft extension.
NOTICE
Do not forget to install thrust washer
and conical spring washer as per illustration
that follows.
NOTE: Install conical spring washer with its con-
cave side towards drive pulley.
DRIVE
13