BRP Can-Am Outlander 2015 Series Manual page 461

vmr2012-028-008_a
1. Fuel tank vent hose inlet
2. Gauge connector
5. Remove fuel tank cap.
6. Set vacuum/pressure pump to PRESSURE and
activate pump. The gauge on the pump should
not change in reading.
7. Set vacuum/pressure pump to VACUUM and
activate pump. The gauge should increase in
reading.
If the test failed, carry out the following:
– Ensure breather filter is properly installed, refer
PERIODIC MAINTENANCE PROCEDURES
to
– Ensure inlet check valve is properly installed, re-
FUEL TANK VENT VALVE INSTALLATION
fer to
in this subsection.
– Test inlet check valve separately. If good, re-
place the breather filter, refer to
MAINTENANCE PROCEDURES
Pressure Relief Valve Test
1. Install the small hose pincher between the inlet
check valve and the fuel pump vent inlet fitting.
vmr2012-028-003_e
1. Inlet check valve
2. Fuel pump vent inlet fitting
3. Install small hose pincher here
vmr2013-028
Subsection XX (FUEL TANK AND FUEL PUMP)
2. Set vacuum/pressure pump to PRESSURE and
activate pump. The gauge should increase in
reading.
3. Set vacuum/pressure pump to VACUUM and
activate pump. The gauge on the pump should
not change in reading.
If the test failed, carry out the following:
– Ensure pressure relief valve is properly in-
stalled, refer to
INSTALLATION
– Replace pressure relief valve if it fails the test.
.
vmr2012-028-029_b
1. Pressure relief valve flow direction arrow
Fuel Tank Vent Valve Installation
Inlet Check Valve Installation
PERIODIC
.
Ensure white portion of inlet check valve is to-
wards the vent breather filter.
vmr2012-028-029_a
1. Vent breather filter
2. White portion of inlet check valve
Pressure Relief Valve Installation
Ensure pressure relief valve flow arrow is pointing
away from fuel pump vent fitting.
PRESSURE RELIEF VALVE
in this subsection.
19