BRP Can-Am Outlander 2015 Series Manual page 70

tmr2011-010-005_a
1. Outlet bore to the engine oil providing system
2. Inlet bore from the oil pump to the oil filter
2. Install a NEW O-ring on oil filter cover.
3. Install the filter into the cover.
4. Apply engine oil on O-ring and on end of filter.
vmr2006-008-001_a
1. Slightly oil
2. Slightly oil
5. Install the cover on the engine.
6. Tighten oil filter cover screws to recommended
torque.
OIL FILTER COVER SCREWS
Tightening torque
7. Reinstall remaining parts if applicable.
vmr2013-056
Subsection 03 (PERIODIC MAINTENANCE PROCEDURES)
10 N•m ± 1 N•m
(89 lbf•in ± 9 lbf•in)
ENGINE (COOLING SYSTEM)
Recommended Engine Coolant
COOLANT
BRP
BRP PREMIXED COOLANT
RECOMMENDED
PRODUCT
ALTERNATIVE,
OR IF NOT
AVAILABLE
NOTICE
Always use
tifreeze containing corrosion inhibitors specif-
ically formulated for internal combustion
aluminum engines.
Engine Coolant Level Verification
WARNING
Check coolant level with engine cold. Never
add coolant in cooling system when engine is
hot.
1. Place vehicle on a level surface.
2. Remove service cover. Refer to
tion.
With the vehicle on a level surface, coolant level
should be between the MIN. and MAX. marks of
the reservoir.
vmr2013-056-003_a
1. Engine coolant reservoir
NOTE: When checking level at temperature
lower than 20°C (68°F), it may be slightly lower
than MIN. mark.
3. Add coolant up to MAX. mark if required.
(P/N 219 700 362)
Distilled water and
antifreeze solution
(50% distilled water,
50% antifreeze)
ethylene-glycol an-
BODY subsec-
7