BRP Can-Am Outlander 2015 Series Manual page 606

Subsection XX (DYNAMIC POWER STEERING (DPS))
MULTIMETER PROBE POSITIONS
DPS2 power
connector pin A
Battery ground
DPS2 power
connector pin B
rmr2008-028-091_a
If NO voltage is measured, test the 40 A DPS fuse
in the rear fuse box (PF2-F3). If good, check wires
and connector pins. Replace or repair defective
parts and reset fault codes.
If battery voltage is measured, carry out the fol-
lowing DPS UNIT INPUT VOLTAGE TEST (CON-
TROL SIDE) .
NOTE: This test may also be carried out by con-
necting a 12 Vdc test light between each DPS
PWR connector pins (A and B), and the battery (-)
negative terminal. The test light must come on
bright.
DPS Unit Input Voltage Test (Control
Side)
1. Disconnect DPS CTRL (control) connector.
2. Set the ignition switch to ON.
3. Set the engine RUN/STOP switch to RUN.
4. Test for 12 Vdc power to the DPS module at
DPS1-A as per following table.
MULTIMETER PROBE
POSITIONS
DPS control connector (pin A)
and battery ground
rmr2008-028-093_a
If NO voltage is measured, check wires and con-
nector pins from DPS unit to the Relays/Speedo
fuse in front fuse box (PF1-F4). Replace or repair
defective parts and reset fault codes.
12
If battery voltage is measured, carry out the fol-
VOLTAGE
lowing
NOTE: This test may also be carried out by con-
necting a 12 Vdc test light between the DPS con-
trol connector (pin A), and the battery (-) negative
terminal. The test light must come on bright.
Battery
DPS Unit Ground Circuit Test
voltage
1. Disconnect the DPS ground connector (GDN).
vmr2010-003-013_c
TYPICAL
1. DPS ground connector (GDN)
2. Test for continuity between DPS3-A and
DPS3-B to battery ground.
connector pin A
connector pin B
If there is NO continuity or a high resistance is
VOLTAGE
measured, check wires and connector pins from
DPS unit to chassis ground post. Replace or re-
pair defective parts and reset fault codes.
If there is good continuity, carry out the following
DPS UNIT COMMUNICATION LINK (CAN) CON-
TINUITY TEST
Battery voltage
NOTE: This test may also be carried out by con-
necting a 12 Vdc test light between each GDN
connector pin and the battery (+) positive termi-
nal. The test light must come on bright.
DPS UNIT GROUND CIRCUIT TEST
MULTIMETER PROBE
POSITIONS
DPS GDN
Battery ground
DPS GDN
.
.
READING
Continuity
(close to 0 )
vmr2013-040