Brake Disc - BRP Can-Am Outlander 2015 Series Manual

7. Ensure brake pad spring is properly positioned
onto caliper and not damaged.
vmr2012-042-011_a
BRAKE PAD SPRING
8. Ensure pad stopper is properly aligned with
caliper support protrusion.
vmr2012-042-012_a
1. Pad stopper
2. Caliper support protrusion
NOTICE
Prior to installing brake pads, pad
stopper must be properly positioned and not
damaged.
9. Install NEW brake pads.
10. Clean and install brake pad pin on caliper.
11. Install pin retainer to secure brake pad pin.
12. Slide caliper support completely into caliper.
vmr2013-044
Subsection XX (BRAKES)
vmr2012-042-014_a
1. Caliper support
13. Install caliper, refer to
TION in this subsection.

BRAKE DISC

Brake Disc Inspection
1. Check disc surfaces for scratches or grooves on
both sides.
2. Measure thickness of the disc.
DISC MINIMUM THICKNESS
FRONT
REAR
NOTICE
Brake discs must never be ma-
chined.
3. Check warpage of the disc.
MAXIMUM DISC WARPAGE
FRONT
REAR
Brake Disc Replacement
1. Remove caliper, refer to
this subsection.
2. Remove wheel hub, refer to
REAR DRIVE
subsection.
3. Remove screws securing brake disc to wheel
hub.
CALIPER INSTALLA-
4.0 mm (.157 in)
4.0 mm (.157 in)
0.2 mm (.01 in)
CALIPER REMOVAL in
FRONT DRIVE
or
17