BRP Can-Am Outlander 2015 Series Manual page 284

Vmr2012-018-017_a
1000 ENGINE
1. Cam
2. Spring end
3. Spring bore
Install pre-assembled cam with spring and driven
pulley on countershaft end.
NOTICE
Cam must engage on countershaft
splines.
Vmr2012-018-018_a
1000 ENGINE
1. Countershaft splines
2. Cam
3. Spring
4. Sliding sheave
5. Fixed sheave
With your hand, push the driven pulley onto the
shaft to compress the spring.
As you hold the pulley in, install a NEW driven pul-
ley screw and thrust washer.
NOTICE
This assembly uses a stretch screw.
Always install a NEW screw.
NOTE: Tighten the screw with your hand approx-
imately 3 to 4 turns.
vmr2013-059
Subsection 11 (CONTINUOUSLY VARIABLE TRANSMISSION (CVT))
Vmr2012-018-011_a
1. Driven pulley screw
2. Thrust washer
Insert a screwdriver of approximately 5 mm
(.197 in) diameter in the cam.
NOTE: For clarity of understanding, some parts
not shown in the following illustration.
Vmr2012-018-019_a
1000 ENGINE
1. Cam
2. Screwdriver, diameter 5 mm (.197 in)
Hold the driven pulley in a fix position.
REQUIRED TOOL
CLUTCH HOLDER
(P/N 529 036 238)
21