Acs Compressor - BRP Can-Am Outlander 2015 Series Manual

3. Set the
FLUKE 115 MULTIMETER (P/N 529 035
to .
868)
4. Measure resistance as per the following table.
Outlander 1000 LTD
TEST PROBES
Module pin 8 (OR/PK)
Relay ground wire
(OR/PK)

ACS COMPRESSOR

ACS Compressor Operation Test
1. Connect vehicle to B.U.D.S. Refer to
NICATION TOOLS AND B.U.D.S. SOFTWARE
subsection of the appropriate Shop Manual.
2. Select Activation page.
3. Select ACS folder.
4. Press Compressor button to proceed.
vmr2010-004-201_c
Step 1: Activation page
Step 2: ACS folder
Step 3: Compressor operation test button
5. Verify if compressor works properly.
ACS Compressor Power Wire
Continuity Test (from Relay)
1. Remove relay, refer to
beginning of this section.
2. Disconnect compressor connector.
vmr2013-043
Subsection XX (AIR CONTROLLED SUSPENSION (ACS))
RESISTANCE
Close to 0
COMMU-
FUSE AND RELAY at the
vmr2013-043-002_a
1. Compressor connector
3. Set the
FLUKE 115 MULTIMETER (P/N 529 035
to .
868)
4. Measure resistance as per the following table.
Outlander 1000 LTD
TEST PROBES
Compressor pin C
(RD/WH)
Terminal 87 (RD/WH))
ACS Compressor Input Voltage Test
1. Release air pressure, refer to
PRESSURE IN SYSTEM FOR SERVICING
subsection.
2. Set the
FLUKE 115 MULTIMETER (P/N 529 035
to Vdc.
868)
3. Disconnect compressor connector.
vmr2013-043-002_a
1. Compressor connector
4. Place ignition switch to ON position.
5. Probe compressor connector.
6. Press MODE (M) button to display AIR_SUSP.
RESISTANCE
Close to 0
RELEASING AIR
in this
15