BRP Can-Am Outlander 2015 Series Manual page 71

Subsection 03 (PERIODIC MAINTENANCE PROCEDURES)
WARNING
Do not remove the coolant reservoir cap if en-
gine is hot.
4. Use a funnel to avoid spillage. Do not overfill.
5. Properly reinstall and tighten reservoir cap.
6. Reinstall service cover.
NOTICE
Do not store any objects in the front
service compartment.
Engine Coolant Specific Gravity Check
1. Remove service cover. Refer to
tion.
2. Remove pressure cap.
WARNING
To avoid potential burns, do not remove the
pressure cap if the engine is hot.
3. Using an antifreeze tester,
strength.
MINIMUM RECOMMENDED COOLANT
STRENGTH
-30°C (-22°F)
Engine Cooling System Inspection
1. Check general condition of hoses and clamps
for tightness.
2. Check the leak indicator hose for oil or coolant.
NOTE: Leaking coolant indicates a defective ro-
tary seal. Leaking oil indicates a defective oil seal.
If either seal is leaking, both seals must be re-
placed at the same time. Refer to
SHAFT AND SEALS
in the
subsection.
8
BODY
subsec-
test coolant
WATER PUMP
COOLING SYSTEM
tmr2011-011-004_a
1. Water pump
2. Leak indicator hose
NOTE: Another leak indicator hole is visible on the
PTO side. It provides an indication of the PTO gas-
ket condition. If a liquid leaks from this hole, PTO
gasket replacement is necessary.
tmr2011-011-005_b
TYPICAL
1. Leak indicator hole
2. PTO cover
3. Crankcase PTO, front side
4. Oil cooler (1000 only)
3. Ensure vent hose on coolant expansion tank is
not obstructed.
Engine Cooling System Pressure Cap Test
1. Remove service cover. Refer to
tion.
2. Remove pressure cap.
WARNING
To avoid potential burns, do not remove the
pressure cap if the engine is hot.
BODY
subsec-
vmr2013-056