BRP Can-Am Outlander 2015 Series Manual page 392

Subsection XX (DIAGNOSTIC SYSTEM AND FAULT CODES)
P0132 ECM
P0133 ECM
P0135
ECM
8
ECU int. fault
path no.: electrical
diagnosis for lambda
sensor upstream cat.
max-error
ECU int. fault path no.:
diagnosis lambda
sensor upstream
catalyst
ECU int. fault path no.:
lambda sensor heating
upstream cat.
Damaged O2 sensor,
damaged circuit wires,
damaged connector or
damaged ECM output pins.
Damaged O2 sensor,
damaged circuit wires,
damaged connector or
damaged ECM output pins.
Damaged O2 sensor,
damaged circuit wires,
damaged connector or
damaged ECM output pins.
Check fuse.
Disconnect HO2S1.
Measure voltage between
harness connector HO2S1-C
and ground (expected
value = 11 to 13 volts).
Measure resistance between
HO2S1 pin C and D (expected
value = 7 to 12 ohms).
Disconnect ECM-B.
Measure resistance
between harness connector
HO2S1-D and ground
(expected value > open).
Measure resistance
from harness connector:
HO2S1-D to ECMB-L2
(expected value: < 2 ohms).
Check fuse.
Disconnect HO2S1.
Measure voltage between
harness connector HO2S1-C
and ground (expected
value = 11 to 13 volts).
Measure resistance between
HO2S1 pin C and D (expected
value = 7 to 12 ohms).
Disconnect ECM-B.
Measure resistance
between harness connector
HO2S1-D and ground
(expected value > open).
Measure resistance
from harness connector:
HO2S1-D to ECMB-L2
(expected value: < 2 ohms).
Check fuse.
Disconnect HO2S1.
Measure voltage between
harness connector HO2S1-C
and ground (expected
value = 11 to 13 volts).
Measure resistance between
HO2S1 pin C and D (expected
value = 7 to 12 ohms).
Disconnect ECM-B.
Measure resistance
between harness connector
HO2S1-D and ground
(expected value > open).
Measure resistance
from harness connector:
HO2S1-D to ECMB-L2
(expected value: < 2 ohms).
tmr2013-025