BRP Can-Am Outlander 2015 Series Manual page 522

vsi2009-018-031
Press and HOLD the selector button for 2 seconds
to reset the trip meter.
Trip Hour Meter (TH)
The trip hour meter records vehicle running time
when the electrical system is activated. It can be
used to establish traveling time between 2 places.
vsi2009-018-032
Press and HOLD the selector button for 2 seconds
to reset the hour meter.
Engine Hour Meter (EH)
The engine hour meter records engine running
time.
vsi2009-018-033
Message Display Mode
If an abnormal engine condition occurs, a mes-
sage may scroll across the main screen in con-
junction with a pilot lamp.
Refer to DIAGNOSTIC SYSTEM AND FAULT
CODES subsection.
vmr2013-035
Subsection XX (LIGHTS, GAUGE AND ACCESSORIES)
Navigating the LCD Gauge
Never adjust or set functions on the multi-
function gauge while riding the vehicle.
Default Display Mode
After vehicle startup, the default display mode is
either:
– Vehicle speed
– Engine revolutions per minute (RPM)
– Both parameters simultaneously (combined
mode).
To change from one display to the other, proceed
as follows.
1. Turn ignition key to ON to power-up the system.
2. Wait until the "greeting message" has been
displayed.
3. Press and release selector button once to dis-
play OD (odometer).
4. Press the selector button again, this time for 2
seconds.
This will change the Mode to either Speed, RPM
or Combined.
vdd2008-001-083
5. To select another mode, repeat steps 3 and 4
until the desired mode is displayed.
Temporary Display Mode
In the temporary display mode, the following func-
tions are available:
– Odometer
– Clock
– Trip meter (resettable)
– Trip Hour meter (resettable)
– Engine hour meter.
Press and release selector button to change the
default display mode to the temporary mode.
WARNING
9