BRP Can-Am Outlander 2015 Series Manual page 167

tmr2011-011-013_a
CRANKCASE PTO SIDE
1. Water pump intermediate drive gear
2. Circlip
3. Water pump intermediate shaft
4. Crankcase PTO side
Water Pump Drive Gear
See BOTTOM END subsection.
Water Pump Gears Removal
Water Pump Gear
1. Remove circlip retaining water pump gear and
discard it.
tmr2011-011-008_a
CRANKCASE MAG SIDE
1. Circlip
2. Water pump gear
2. Remove the following parts:
– Water pump gear
– Needle pin
– Thrust washer.
vmr2013-058
Subsection 05 (COOLING SYSTEM)
tmr2011-011-009_a
CRANKCASE MAG SIDE
1. Water pump gear
2. Needle pin
3. Thrust washer
Water Pump Intermediate Drive Gear
1. Remove circlip retaining water pump interme-
diate drive gear and discard it.
tmr2011-011-013_a
CRANKCASE PTO SIDE
1. Water pump intermediate drive gear
2. Circlip
3. Water pump intermediate shaft
4. Crankcase PTO side
2. Remove the following parts:
– Water pump intermediate drive gear
– Needle pin.
Water Pump Drive Gear
BOTTOM END
See subsection.
Water Pump Gears Installation
Water Pump Gear
Install the following parts on water pump shaft.
– Thrust washer
21