BRP Can-Am Outlander 2015 Series Manual page 435

Using the following tools, check resistance val-
ues.
REQUIRED TOOL
ECM ADAPTER TOOL (P/N 529 036 166)
REQUIRED TOOL
FLUKE 115 MULTIMETER (P/N 529 035 868)
THROTTLE
ECM ADAPTER
POSITION
RESISTANCE ( ) @ 20°C
PIN
710 - 1300
G3 G2
1600 - 2400
G2 A1
2600 - 2700
G3 A1
vmr2008-022-005_a
NOTE: The resistance value should change
smoothly and proportionally to throttle move-
ment. Otherwise, replace TPS.
If resistance values are correct, perform the
INPUT VOLTAGE TEST
If resistance values are incorrect, check wiring
harness. If wiring is faulty, repair/replace. If
wiring is good, replace TPS.
Reconnect ECM connector.
TPS Input Voltage Test
Disconnect connector from TPS.
Turn ignition key ON and.
Set emergency engine stop switch to RUN.
Check the voltage readings from harness connec-
tor as follows.
vmr2013-027
Subsection XX (ELECTRONIC FUEL INJECTION (EFI))
WIDE OPEN
IDLE THROTTLE
POSITION
(68°F)
2600 - 2700
1124 2260
1600 - 2400
1504 1504
710 - 1300
2295 1201
TPS
below.
CONNECTION
Pin 1 with battery ground
Pin 2 with battery ground
Pin 3 with battery
ground: idle
Pin 3 with battery
ground: WOT
smr2005-056-016_a
If voltage test is not good, check/repair wiring
harness. If wiring tests good, refer to
PLACEMENT .
If voltage test is good, everything is in order (as-
suming resistance test was performed).
TPS Replacement
Refer to TPS ACCESS
access to TPS.
Unplug connector from TPS.
Loosen TPS retaining screws.
Remove TPS.
VOLTAGE
5.0 V
0 V
0.5 V
4.75 - 5 V
BAT
ECM RE-
in this subsection to gain
17