BRP Can-Am Outlander 2015 Series Manual page 387

P0032 ECM
P0037 ECM
P0038
ECM
tmr2013-025
Subsection XX (DIAGNOSTIC SYSTEM AND FAULT CODES)
Internal fault path
number for Max error:
power stage of heater
of Sensor upstream
catalyst
Internal fault path
number for Min error :
power stage of heater
of Sensor upstream
catalyst, LSU 2
Internal fault path
number for Max error:
power stage of heater
of Sensor upstream
catalyst, LSU 2
Damaged O2 sensor,
damaged circuit wires,
damaged connector or
damaged ECM output pins.
Blown fuse, damaged or
disconnected O2 sensor,
damaged or disconnected
circuit wires, damaged
ECM output pins.
Blown fuse, damaged or
disconnected O2 sensor,
damaged or disconnected
circuit wires, damaged
ECM output pins.
Check fuse.
Disconnect HO2S1.
Measure voltage between
harness connector HO2S1-C
and ground (expected
value = 11 to 13 volts).
Measure resistance between
HO2S1 pin C and D (expected
value = 7 to 12 ohms).
Disconnect ECM-B.
Measure resistance
between harness connector
HO2S1-D and ground
(expected value > open).
Measure resistance
from harness connector:
HO2S1-D to ECMB-L2
(expected value: < 2 ohms).
Check fuse.
Disconnect HO2S2.
Measure voltage between
harness connector HO2S2-C
and ground (expected
value = 11 to 13 volts).
Measure resistance between
HO2S2 pin C and D (expected
value = 7 to 12 ohms).
Disconnect ECM-B.
Measure resistance
between harness connector
HO2S2-D and ground
(expected value > open).
Measure resistance
from harness connector:
HO2S2-D to ECMB-L3
(expected value: < 2 ohms).
Check fuse.
Disconnect HO2S2.
Measure voltage between
harness connector HO2S2-C
and ground (expected
value = 11 to 13 volts).
Measure resistance between
HO2S2 pin C and D (expected
value = 7 to 12 ohms).
Disconnect ECM-B.
Measure resistance
between harness connector
HO2S2-D and ground
(expected value > open).
Measure resistance
from harness connector:
HO2S2-D to ECMB-L3
(expected value: < 2 ohms).
3