BRP Can-Am Outlander 2015 Series Manual page 293

Subsection XX (GEARBOX AND 4X4 COUPLING UNIT (500/650/800R))
When replacing an oil seal, take this opportunity
to inspect the following:
– Check bearings behind each oil seal for contam-
ination and/or metal shavings.
– Check oil seal running surfaces for scratches.
Oil Seal Lubrication
When installing or reinstalling oil seals, use
PETAMO GREASE GHY 133N (P/N 420 899 271)
– Lubricate sealing lips all around.
– Fill up the room between sealing lips halfway
around the perimeter.
vmr2013-020-001_a
1. Sealing lips
2. Room between sealing lips
Countershaft Oil Seal
The countershaft oil seal can be removed without
removing gearbox from vehicle. Remove drive
and driven pulley and CVT air guide.
vmr2006-022-006_a
1. Countershaft oil seal
2. Distance sleeve
vmr2012-019
NOTE: When oil seal is removed also inspect
O-ring.
to:
vmr2012-019-006_a
1. Distance sleeve
2. O-ring
For countershaft oil seal installation use the fol-
lowing service tool.
COUNTERSHAFT OIL SEAL
PUSHER (P/N 529 036 222)
vmr2012-019-007_a
1. Countershaft oil seal
2. Oil seal pusher
Shift Shaft Oil Seal
The shift shaft oil seal can be removed without
removing the gearbox from the vehicle.
To replace the shift shaft oil seal, refer to
and remove:
– Seat
REQUIRED TOOL
BODY
7