BRP Can-Am Outlander 2015 Series Manual page 140

vbs2008-011-035_a
TYPICAL
1. Oil seal properly seated
6. Apply engine oil on water pump shaft.
7. Place rotary seal onto water pump shaft and pull
out water pump shaft by hand.
NOTICE
Do not install the rotary seal com-
pletely into the crankcase to prevent the water
pump shaft plastic gear from breaking. Push it
partially in, then pull the shaft.
8. Place a robust M8 flat washer (P/N 420 227
935) onto water pump shaft.
9. Install a M8 x 1.25 nut (P/N 233 281 414) onto
water pump shaft by hand.
10. Thread nut 1-1/2 turns to pull the shaft into
rotary seal.
tmr2011-011-057_a
1. Rotary seal
2. M8 robust flat washer (P/N 420 227 935)
3. M8 x 1.25 nut (P/N 233 281 414)
11. Remove M8 nut.
NOTE: The robust M8 flat washer must remain on
water pump shaft.
12. Install rotary seal
crankcase as follows.
vmr2013-013
installation tools on
Subsection XX (COOLING SYSTEM)
REQUIRED TOOLS
ROTARY SEAL PUSHER PLATE
(P/N 529 036 130)
4x M6 x 85 screws (P/N 420 440 347)
4x tubes 70 mm (2.75 in)
SEAL PUSHER (P/N 529 035 766)
529036130
ROTARY SEAL PUSHER PLATE (P/N 529 036 130)
529035766
SEAL PUSHER (P/N 529 035 766)
tmr2011-011-058_a
ROTARY SEAL PUSHER PLATE ASSEMBLY
1. 4 x tubes (70 mm (2.75 in) length)
2. 4 x screws M6 x 85
3. Plane surface on pusher bolt
15