BRP Can-Am Outlander 2015 Series Manual page 122

Subsection XX (LUBRICATION SYSTEM)
OIL PUMP
Oil Pump Location
The oil pump is located on the engine PTO side
(behind PTO cover).
vmr2006-042-009_a
1. Oil pump
Oil Pump Removal
Remove the PTO cover. Refer to
the BOTTOM END subsection.
1. Remove:
– Retaining ring
– Oil pump gear
– Needle pin
– Thrust washer.
tmr2011-010-011_a
1. Thrust washer
2. Needle pin
3. Oil pump gear
4. Retaining ring
2. Remove oil pump cover screws and pull oil
pump cover out.
8
vmr2006-042-011_a
1. Retaining screws
2. Oil pump cover
3. Remove oil pump shaft with needle pin and in-
ner rotor.
4. Remove outer rotor.
PTO COVER in
tmr2011-010-012_a
1. Outer rotor
2. Needle pin
3. Oil pump shaft
4. Inner rotor
Oil Pump Inspection
Inspect oil pump and oil pump cover bore for
marks, scratches or other damages. Check for
scratches in crankcase between outer rotor and
oil pump bore. If so, replace damaged parts.
Check oil pump cover for damages and for surface
straightness with a straightedge.
vmr2013-012