BRP Can-Am Outlander 2015 Series Manual page 457

vmr2012-028-026_a
FUEL PUMP REMOVAL
1. Fuel pump retaining nut
5. Carefully pull out and rotate fuel pump as re-
quired.
NOTICE
Pay attention not to damage fuel
sender and fuel pump prefilter.
vmr2012-028-027_a
1. Approximate float orientation
2. Approximate prefilter orientation
6. Discard gasket ring.
7. Wipe off any fuel spillage.
Fuel Pump Installation
For installation, reverse the removal procedure.
However, pay attention to the following.
Rotate fuel pump during insertion as per removal
procedure.
CAUTION Pay attention not to damage
fuel sender and fuel pump prefilter.
1. Install a NEW gasket ring.
vmr2013-028
Subsection XX (FUEL TANK AND FUEL PUMP)
2. Place gasket so that it is properly located be-
tween fuel pump and fuel pump mounting neck
on fuel tank.
vmr2012-028-028_a
1. Gasket ring here
2. Fuel pump flange
Ensure gasket ring makes good contact all
around fuel pump and fuel pump mounting
neck on fuel tank.
3. Ensure proper fuel pump orientation as in fol-
lowing illustration.
vmr2012-028-007_a
1. Fuel tank pump index
2. Fuel pump index
4. Insert fuel pump retaining nut over the fuel
pressure hose and electrical wiring connector.
5. While firmly holding pump against tank, engage
fuel pump retaining nut on fuel tank flange.
NOTE: If necessary, move the pump in order to
ensure the flange is sitting completely flat on the
tank.
6. Tighten fuel pump retaining nut to specification.
WARNING
15