BRP Can-Am Outlander 2015 Series Manual page 752

Subsection 08 (BODY (OUTLANDER X mr))
vmr2012-043-008_a
TYPICAL - RH SIDE SHOWN
1. Screw securing front fender
13. With the assistance of a person, pull front
body module forward.
14. Install front body module on a stable and clean
support.
Front Body Module Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
Tighten front fender screws to specification.
TIGHTENING TORQUE
Screws securing footrest
panels to front fenders
Screws securing front
fenders to frame
REAR BODY MODULE
Rear Body Module Removal
1. Remove seat.
2. Remove the following panels, see procedure in
this section.
– LUGGAGE TRAY (X mr 1000 MODELS)
– Rear bumper (X mr 1000 Models)
SIDE PANEL
– .
3. On 650 Models, remove rear top panel retain-
ing screws.
12
4.5 N•m ± 0.5 N•m
(40 lbf•in ± 4 lbf•in)
4.5 N•m ± 0.5 N•m
(40 lbf•in ± 4 lbf•in)
vmr2012-043-009_a
TYPICAL
1. Rear top panel retaining screws
4. Disconnect taillights connectors.
vmr2012-043-010_a
LH SIDE SHOWN
1. Taillight connector
5. Move aside taillight harness from rear body
module (on both sides).
vmr2012-043-029
TYPICAL - LH SIDE TAILLIGHT HARNESS
6. Disconnect connectors from voltage regulator
rectifier.
vmr2013-067