Chassis (Body); Chassis (Frame) - BRP Can-Am Outlander 2015 Series Manual

Brake Fluid Bleeding (Procedure Using a
Vacuum Pump)
NOTE: Brake fluid reservoir must be kept full to
prevent air from being pumped into the system.
1. Unscrew all bleeders until brake fluid comes
out then close it.
NOTE: To locate all bleeders according to ve-
hicle configuration, refer to
and BRAKE CIRCUIT CONFIGURATIONS
BRAKES subsection.
2. Install the Vacuum/pressure
bleeder.
REQUIRED TOOL
VACUUM/PRESSURE
PUMP
(P/N 529 021 800)
3. Place pump to vacuum position.
4. Pump vacuum pump a few times.
5. Loosen bleeder.
6. Continue to pump until no more air bubbles ap-
pear in clear hose.
7. Close then tighten bleeder.
BLEEDER
Tightening Torque
8. Add recommended brake fluid to MAX. mark.
Do not overfill.
9. Perform bleeding procedure for the other bleed-
ers.
10. Check brakes operation:
– If brakes feel spongy, bleed system again
then carry out the
SURE VALIDATION
subsection.
Brake Fluid Bleeding (Manual Procedure)
NOTE: Brake fluid reservoir must be kept full to
prevent air from being pumped into the system.
1. Connect a clear hose onto bleeder.
2. Pump up system pressure slowly using brake
pedal and/or lever(s) until resistance is felt.
3. Depress and hold brake pedal and/or lever(s).
4. Open bleeder and then close it.
5. Release brake pedal and/or lever(s) slowly.
vmr2012-005
Subsection XX (PERIODIC MAINTENANCE PROCEDURES)
EXPLODED VIEW
. See
pump onto
5.5 N•m ± 1.5 N•m
(49 lbf•in ± 13 lbf•in)
BRAKE SYSTEM PRES-
BRAKES
as detailed in
NOTE: Do not release brake pedal and/or lever(s)
until bleeder has been closed.
6. Repeat procedure until fluid flows out without
any air bubbles.
7. Tighten bleeder.
BLEEDER
Tightening Torque
8. Perform bleeding procedure for the other bleed-
ers.
NOTE: To locate all bleeders according to ve-
hicle configuration, refer to
BRAKE CIRCUIT CONFIGURATIONS
and
BRAKES subsection.
9. Check brakes operation:
– If brakes feel spongy, bleed system again
then carry out the
SURE VALIDATION
subsection.

CHASSIS (BODY)

Seat Latch Inspection and Operation
Ensure seat latch functions properly and that seat
is properly secured when latched.
Rear Cargo Compartment Latch
Inspection and Operation
Ensure cargo compartment latch functions prop-
erly and that compartment panel is properly se-
cured when latched.

CHASSIS (FRAME)

Frame Inspection
Inspect frame for damages such as:
– Cracks
– Dents
– Twisting
– Deformation
– Corrosion
– Loose fasteners.
Pay particular attention to:
– Front and rear frame extensions (body mod-
ules)
– Underside of frame
– Suspension attachment points
– Engine attachment points.
5.5 N•m ± 1.5 N•m
(49 lbf•in ± 13 lbf•in)
EXPLODED VIEW
. See
BRAKE SYSTEM PRES-
BRAKES
as detailed in
23