BRP Can-Am Outlander 2015 Series Manual page 11

INTRODUCTION
NOTE: If it is difficult to readjust, heat screw with
a soldering iron (232°C (450°F)).
Application for Stripped Thread Repair
1
2
3
4
A00A3QA
1. Release agent
2. Stripped threads
3. Form-A-Thread
4. Tape
5. Cleaned bolt
6. Plate
7. New threads
8. Threadlocker
Standard Thread Repair
Follow instructions on Loctite FORM-A-THREAD
81668 package.
If a plate is used to align bolt:
1. Apply release agent on mating surfaces.
2. Put waxed paper or similar film on the surfaces.
3. Twist bolt when inserting it to improve thread
conformation.
NOTE: NOT intended for engine stud repairs.
Repair of Small Holes/Fine Threads
Option 1: Enlarge damaged hole, then follow
STANDARD THREAD REPAIR
Option 2: Apply FORM-A-THREAD on the screw
and insert in damaged hole.
Permanent Stud Installation (Light Duty)
1. Use a stud of the desired thread length.
NOTE: DO NOT apply release agent on stud.
2. Follow Standard Thread Repair procedure.
3. Allow 30 minutes for Loctite FORM-A-THREAD
to cure.
4. Complete part assembly.
X
5
6
8
7
procedure.
Gasket Compound Application
1
1
lmr2007-040-006_a
1. Proper strength Loctite
2. Loctite Primer N (P/N 293 800 041) and Gasket Eliminator 518
(P/N 293 800 038) on both sides of gasket
3. Loctite Primer N only
1. Remove old gasket and other contaminants us-
ing
LOCTITE CHISEL (GASKET REMOVER) (P/N 413
. Use a mechanical means only if nec-
708 500)
essary.
NOTE: Avoid grinding.
2. Clean both mating surfaces with solvent.
3. Spray Loctite Primer N on both mating surfaces
and on both sides of gasket and allow to dry 1
or 2 minutes.
4. Apply
LOCTITE 518 (P/N 293 800 038)
sides of gasket, using a clean applicator.
5. Place gasket on mating surfaces and assemble
parts immediately.
NOTE: If the cover is bolted to blind holes, apply
proper strength Loctite in the hole and on threads.
Tighten fastener.
NOTE: If holes are sunken, apply proper strength
Loctite on bolt threads.
6. Tighten as usual.
2
1
3
on both
vmr2013-002