BRP Can-Am Outlander 2015 Series Manual page 677

vmr2013-043-019_a
TYPICAL - PARTS REMOVED FOR CLARITY
1. Compressor support rear retaining bolts
2. Compressor support side retaining bolt
12. Remove compressor front retaining screw.
vmr2013-043-020_a
1. Front retaining screw
13. Remove compressor from vehicle by pulling it
upwards.
14. Detach compressor connector from compres-
sor support.
15. Remove mounting nuts from compressor sup-
port.
16. Remove rear compressor support from com-
pressor.
vmr2013-065
Subsection XX (AIR CONTROLLED SUSPENSION (ACS))
vmr2013-043-013_a
TYPICAL
1. Compressor front support mounting bolts
vmr2013-043-003_a
TYPICAL
1. Compressor rear support mounting nuts
NOTICE
compressor.
17. Remove the following fittings from compres-
sor.
– Compressor air inlet fitting
– Compressor air outlet fitting.
vmr2013-043-018_a
TYPICAL
1. Compressor air inlet fitting
2. Compressor air outlet fitting
ACS Compressor Installation
The installation procedure is the reverse of re-
moval procedure, however pay attention to the
following.
If fitting or valve is the one previously removed
(old one), apply
(P/N 293 800 018)
Do not remove front support from
LOCTITE 592 (PIPE SEALANT)
on all male threads.
17