BRP Can-Am Outlander 2015 Series Manual page 360

Fault Code States
Fault codes have 3 possible states:
– Active
– Occurred
– Inactive.
Click the Fault tab then click on the drop-down list
on the LH lower corner.
Choose the fault code state you want to display.
rmr2011-021-001_a
TYPICAL
1. Drop down list
Active Fault Codes
An active fault code is an indication of a fault that
is currently triggered.
The active fault may or may not compromise
normal operation of the system(s). Service ac-
tion should be taken to correct the problem that
caused the fault code.
Once the fault condition(s) of the active fault is no
longer present, its state will change to "occurred".
Occurred Fault Codes
An occurred fault code indicates a fault that was
active, but no longer is.
The occurred fault does not presently affect sys-
tem or component operation but is retained as a
history of the faults that were detected.
The fault may have been generated due to a
system or component that was momentarily op-
erating outside normal parameters. Repeated
occurred faults of this type should be considered
when troubleshooting a problem, and may require
that maintenance action be taken.
An occurred fault may also be generated when
disconnecting and reconnecting a component, re-
placing a burnt fuse, when the software update of
an electronic module has been carried out, or may
be due to a momentary high or low voltage.
Inactive Fault Codes
An inactive fault code represents a fault code that
is neither active, nor occurred. It is simply part of
a list of all possible faults that can be monitored
by the ECM and multifunction gauge, which may
vmr2013-026
Subsection XX (DIAGNOSTIC SYSTEM AND FAULT CODES)
become active or occurred if the monitoring sys-
tem detects an applicable fault. These codes can
be viewed in B.U.D.S.
How to Display Fault Codes in the
Multifunction Gauge
NOTE: A fault code must be in an "Active" state to
be displayed in the multifunction gauge. B.U.D.S.
must be used to read all fault codes states.
1. Use the selector button or mode button and
vmo2012-012-029_q
MULTIFUNCTION GAUGE LCD - OUTLANDER
1. Selector button
vmo2013-007-001
MULTIFUNCTION GAUGE (ANALOG/DIGITAL) - OUTLANDER
1. Mode button
vmr2007-050-002_c
RENEGADE
1. Selector button
scroll to Engine Hour (EH) on the gauge.
1
M
M
S
S
3