BRP Can-Am Outlander 2015 Series Manual page 773

Subsection XX (BODY (RENEGADE))
8. Place a clean rag into fuel tank filler tube.
9. Remove rear body module by pulling it rear-
wards.
10. Install rear body module on an appropriate
support.
11. Remove rag and reinstall fuel tank cap.
WARNING
Fuel vapors are flammable and explosive
under certain conditions. Unless otherwise
noted, the fuel tank cap must always be in-
stalled on vehicle.
Rear Body Module Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
Tighten rear body module fasteners to specifica-
tion.
TIGHTENING TORQUE
Screws securing rear
fender to footrest panel
Rear anchors retaining
screws
Bolts securing rear
fender to frame
CONSOLE
Console Removal
1. Remove seat.
2. Pull both front pins out of their grommets.
3. Pull both front hooks out of their slots.
vbl2012-007-005_a
1. Console
2. Pin
3. Hook
4. Slot
5. Grommet
4. Pull rear portion of the console up to pull the
pins of their grommets.
10
2.5 N•m ± 0.5 N•m
(22 lbf•in ± 4 lbf•in)
4.5 N•m ± 0.5 N•m
(40 lbf•in ± 4 lbf•in)
2.5 N•m ± 0.5 N•m
(22 lbf•in ± 4 lbf•in)
5. Remove console by pulling it rearwards.
vbl2012-007-006_a
Step 1: Pull upwards
Step 2: Pull rearwards
Console Installation
The installation is the reverse of the removal pro-
cedure.
GAUGE SUPPORT
LIGHTS, GAUGE AND ACCESSORIES
Refer to
subsection.
INNER FENDER PANELS
Inner Fender Panel Removal
Remove the following plastic rivets from inner
fender panel.
vmr2012-047-012_a
SOME PARTS REMOVED FOR CLARITY
1. Plastic rivets (2 on RH side)
vmr2013-046