BRP Can-Am Outlander 2015 Series Manual page 163

12. Install rotary seal
crankcase as follows.
NOTE: Make sure pusher bolt has a plane
surface.
12.1 Apply a little grease at the end of tool
pusher bolt.
12.2 Ensure that pusher bolt is completely un-
screwed.
12.3 Install rotary seal pusher plate on
crankcase by tightening M6 screws.
NOTICE
Do not use pneumatic or elec-
tric tools for tightening screws.
tmr2011-011-059_a
ROTARY SEAL PUSHER PLATE INSTALLATION
1. Rotary seal pusher plate
2. Tube (70 mm (2.75 in) length)
3. M6 x 85 screw
4. Pusher bolt
12.4 Install seal pusher between rotary seal
pusher plate and water pump shaft.
tmr2011-011-060_a
SEAL PUSHER INSTALLATION
1. Seal pusher aligned with pusher bolt
12.5 Tighten the pusher bolt by hand until it
stops against the seal pusher.
13. Carefully thread the pusher bolt 1-1/2 turns.
vmr2013-058
installation tools on
Subsection 05 (COOLING SYSTEM)
14. Ensure that the rotary seal is going straight
into crankcase.
15. Remove rotary seal installation tools from
crankcase.
9 TO 15
16. Repeat steps
pletely seated in the crankcase.
vbs2008-011-037
ROTARY SEAL PROPERLY SEATED ON CRANKCASE
17. Carry out the final adjustment of the water
pump shaft as follows.
17.1 Install M8 x 1.25 nut (P/N 233 281 414)
onto water pump shaft.
17.2 Carefully thread M8 nut until the rotary
seal is flush with the end of water pump
shaft threads.
vbs2008-011-040
WATER PUMP SHAFT PROPERLY ADJUSTED WITH ROTARY
SEAL
NOTICE
The water pump shaft must
be properly adjusted with rotary seal.
The water pump shaft must move freely
while pushing it toward the crankcase.
18. Install the following parts, see procedure in
this subsection.
WATER PUMP IMPELLER
–
WATER PUMP HOUSING
–
until rotary seal is com-
.
17