BRP Can-Am Outlander 2015 Series Manual page 302

Subsection XX (GEARBOX AND 4X4 COUPLING UNIT (500/650/800R))
RIGHT HOUSING M8 SCREWS
Tightening
Torque Hand tightened
(step 1)
Tightening
Torque 25 N•m ± 3 N•m (18 lbf•ft ± 2 lbf•ft)
(step 2)
vmr2006-022-036_a
Tighten all M6 Torx screws to specification
RIGHT HOUSING M6 SCREWS
Tightening Torque
Before installing bearing cover, apply
on the housing and
5910 (P/N 293 800 081)
LUBE GREASE (P/N 293 550 030)
Install the actuator, refer to
subsection.
Once this is done, complete final assembly.
GEARBOX
Gearbox Removal
Remove engine from vehicle and place it on
footrest support. Refer to
AND INSTALLATION
for the procedure.
Drain gearbox. Refer to
ING PROCEDURE in PERIODIC MAINTENANCE
PROCEDURES subsection.
Remove drive and driven pulley and CVT air guide,
CONTINUOUSLY VARIABLE TRANSMIS-
refer to
SION (CVT)
subsection.
Unscrew the three (3) nuts that attach the gearbox
to the engine.
16
10 N•m ± 1 N•m
(89 lbf•in ± 9 lbf•in)
LOCTITE
SUPER
on oil seal.
ACTUATOR
in this
ENGINE REMOVAL
GEARBOX OIL DRAIN-
Pull gearbox to separate it from engine.
Gearbox Disassembly
NOTE: During gearbox disassembly, inspect the
condition of each part closely.
Remove the output shaft. Refer to
SHAFT AND COUPLING MECHANISM
subsection.
Push bevel gear with a pin slightly down and mea-
sure the axial clearance of bevel gear with a feeler
gauge.
NOTE: Bevel gear axial clearance must be mea-
sured before center and left housings separation.
vmr2006-022-040_a
1. Bevel gear
vmr2006-022-041
MEASURE AXIAL CLEARANCE OF BEVEL GEAR
OUTPUT
in this
vmr2012-019