BRP Can-Am Outlander 2015 Series Manual page 61

Subsection XX (PERIODIC MAINTENANCE PROCEDURES)
– Check cleanliness of master cylinder rod and
boot
– Check master cylinder boot for cracks or
damage. Replace as necessary.
Hand Lever
Check hand lever as follows:
– Lever pivot bolt cleanliness
– Lever pivot bolt movement.
Brake Pedal
1. Check brake pedal as follows:
– Brake pedal pivot movement
– Brake pedal pivot cleanliness.
2. If required, clean then lubricate brake pedal
pivot using
XPS SYNTHETIC GREASE (P/N 293
.
550 010)
Brake Hoses
1. Check hoses for leaks, crushed, deformations,
cracking or scrapes.
NOTE: Any deformation can restrict the proper
flow of fluid and cause braking problems.
Brake Fluid Replacement
Brake Fluid Draining
1. Clean and remove reservoir cover with its di-
aphragm.
2. Connect a clear hose onto bleeder.
tmr2011-037-101_a
TYPICAL
1. Caliper bleeder
3. Loosen bleeder.
4. Pump brake lever(s) and/or brake pedal until no
more fluid flows out.
5. Repeat draining procedure for the other bleed-
ers.
22
NOTE: To locate all bleeders according to ve-
hicle configuration, refer to
BRAKE CIRCUIT CONFIGURATIONS
and
BRAKES
subsection.
Brake Fluid Filling
1. Add recommended brake fluid to MAX. mark.
Do not overfill.
vmo2012-012-046_a
TYPICAL - BRAKE FLUID RESERVOIR
vmo2012-012-035_a
TYPICAL - UNDER THE SEAT
1. Brake fluid reservoir
NOTE: If applicable, ensure filler cap diaphragm is
fully retracted before closing the cap.
RECOMMENDED BRAKE FLUID
DOT 4 BRAKE FLUID (P/N 293 600 131)
WARNING
– Use only DOT 4 brake fluid from a sealed
container.
– Do not use brake fluid from an old or al-
ready opened container.
EXPLODED VIEW
. See
vmr2012-005