Maintenance Schedule - BRP Can-Am Outlander 2015 Series Manual

Subsection 02 (PERIODIC MAINTENANCE SCHEDULE)

MAINTENANCE SCHEDULE

Follow the appropriate maintenance intervals according to the environment where the vehicle is used:
normal environment or extreme environment (mud, water, dust).
EVERY 375 KM (250 MI) OR 12.5 HOURS OF OPERATION IN AN EXTREME
Inspect and clean (or replace if necessary) engine air filter and foam filter. For dusty conditions, we recommend
oiling the foam filter
Inspect and clean CVT air filter
Inspect and clean drain hose and reservoir of the air filter housing
Grease rear propeller shaft joints
Inspect tie rod ends and ball joints
Inspect and lubricate front suspension arms
Inspect and lubricate rear anti-sway bar bushings
Inspect and clean muffler spark arrester
Check brake fluid level.
Inspect brake pads.
Tighten wheel lug nuts.
Inspect the drive shaft boots and protectors.
EVERY 1 500 KM (1,000 MI) OR 50 HOURS OF OPERATION
EVERY 750 KM (500 MI) OR 25 HOURS OF OPERATION IN AN EXTREME
Replace engine air filter and oil foam filter.
Inspect, adjust and lubricate throttle cable.
Check battery condition.
Inspect front differential/rear final drive oil level.
Inspect drive shaft joint condition.
Inspect front/rear propeller shaft joint condition.
Inspect shock absorbers.
Lubricate spherical bearings
Inspect wheel nuts and studs
Inspect steering system (check for abnormal play)
2
EVERY 750 KM (500 MI) OR 25 HOURS OF OPERATION
IN A NORMAL ENVIRONMENT (whichever comes first)
ENVIRONMENT (whichever comes first)
IN A NORMAL ENVIRONMENT (whichever comes first)
ENVIRONMENT (whichever comes first)
vmr2013-055