BRP Can-Am Outlander 2015 Series Manual page 507

Subsection XX (STARTING SYSTEM)
vmr2012-023-003_b
1. Battery support
2. Starter solenoid
3. Battery cable
4. Tool kit
Starter Solenoid Access for Electrical
Testing
For electrical testing, the small starter solenoid
connectors (SS1 and SS2) are accessible through
the battery support.
vmr2012-023-003_c
1. Small starter solenoid connectors (SS1 and SS2)
The larger starter solenoid cables are accessible
from under the RH rear fender.
NOTE: For easier access, detach the fender from
BODY
the footrest, refer to
4
subsection.
vmr2012-033-003_a
1. Cable from starter solenoid to starter
2. Battery cable to starter solenoid (not visible)
3. Fuel tank
4. RH rear fender
Starter Solenoid Wire Identification
FUNCTION
12 volt input from START switch
Ground from ECM pin L13
Starter Solenoid Operational Test
1. Connect 2 wire jumpers to the starter solenoid
as per following table.
STARTER SOLENOID OPERATIONAL TEST
WIRE JUMPER CONNECTIONS
Solenoid contact SS1 to battery (+) terminal (RED)
Solenoid contact SS2 momentarily connected
to chassis ground
If starter runs, carry out the
INPUT VOLTAGE TEST
.
If starter does not run, carry out the
LENOID WINDING RESISTANCE TEST
Starter Solenoid Input Voltage Test
1. Set emergency engine stop switch to RUN po-
sition.
2. Turn ignition switch to ON.
3. Press and hold START button.
4. Measure voltage as per following table.
WIRE
PIN
COLOR
YELLOW/
SS1
RED
ORANGE/
SS2
BROWN
STARTER SOLENOID
STARTER SO-
.
vmr2013-033