BRP Can-Am Outlander 2015 Series Manual page 379

Subsection XX (DIAGNOSTIC SYSTEM AND FAULT CODES)
FAULT REPORTING
CODE MODULE
P0707 ECM
P0708 ECM
P1562 ECM
P1563 ECM
22
DESCRIPTION
Gear position sensor
shorted to ground, or
open circuit
Gear position sensor
circuit shorted to
battery +
Blown fuse FC,
battery failure,
voltage regulator
failure, damaged
System voltage low circuit wires or
(from key switch) connection, damaged
magneto generator.
An external battery
charger may have been
used.
Damaged regulator.
System voltage high An external battery
charger may have been
(from key switch)
used.
POSSIBLE CAUSE
Verify that gear position information
change when you change the
position of gear on vehicle.
Disconnect GBPS.
Measure voltage between harness
connector GBPS-1 and GBPS-3.
(Expected value: 4.8 to 5.1 volts)
Measure resistance from
connector: ECM-D2 to GBPS-2.
(Expected value: < 2 ohms).
Measure resistance from
connector: ECM-C3 to GBPS-3.
(Expected value: < 2 ohms).
Replace GBPS sensor
Verify that gear position information
change when you change the
position of gear on vehicle.
Disconnect GBPS.
Measure voltage between harness
connector GBPS-1 and GBPS-3.
(Expected value: 4.8 to 5.1 volts).
Measure resistance from
connector: ECM-D2 to GBPS-2.
(Expected value: < 2 ohms).
Measure resistance from
connector: ECM-C3 to GBPS-3.
(Expected value: < 2 ohms).
Replace GBPS sensor.
Measure battery voltage with
engine stopped. (Expected
value: 11 to 13 volts).
Measure battery voltage with
engine running. (Expected
value: 13 to 14.7 volts).
Check connections
on voltage regulator.
Check ground and positive
connections on battery.
Check ground on vehicle frame.
Measure battery voltage with
engine stopped. (Expected
value: 11 to 13 volts).
Measure battery voltage with
engine running. (Expected
value: 13 to 14.7 volts).
Check connections
on voltage regulator.
Check ground and positive
connections on battery.
Check ground on vehicle frame.
SERVICE ACTION
vmr2013-026