BRP Can-Am Outlander 2015 Series Manual page 139

Subsection XX (COOLING SYSTEM)
tmr2011-011-054_a
1. Wooden screws
2. Oil seal
7. Remove oil seal from crankcase by pulling
screws with pliers.
tmr2011-011-055_a
1. Pull on screws to remove seal
8. Check water pump shaft axial play.
NOTE: If axial play is not adequate, engine must
be disassembled to replace water pump shaft.
9. Clean oil seal seat.
14
tmr2011-011-056_a
Seals Installation
1. Apply engine oil on water pump shaft.
2. Apply grease on the lips of the oil seal.
3. Carefully install oil seal over the water pump
shaft.
4. Push oil seal into the water pump cavity.
REQUIRED TOOL
17 mm (11/16 in) deep socket
vbs2008-011-034
OIL SEAL INSTALLATION
5. Ensure that the oil seal is properly seated in wa-
ter pump cavity.
vmr2013-013