BRP Can-Am Outlander 2015 Series Manual page 46

16. Stop engine.
17. Wait a while to allow oil to flow down to
crankcase, then check oil level again.
18. Dispose oil and filter as per your local environ-
mental regulations.
Engine Oil Filter Replacement
Engine Oil Filter Access
To reach oil filter, refer to
following parts (Outlander models):
– Seat
– Console
– RH side panel
– RH footrest panel.
Engine Oil Filter Removal
1. Clean oil filter area.
2. Remove oil filter cover screws.
3. Remove oil filter cover.
4. Remove oil filter.
tmr2011-010-004_a
1. Oil filter screw
2. Oil filter cover
3. O-ring
4. Oil filter
Engine Oil Filter Installation
1. Check and clean the oil filter inlet and outlet
area of dirt and other contaminations.
vmr2012-005
Subsection XX (PERIODIC MAINTENANCE PROCEDURES)
BODY and remove the
tmr2011-010-005_a
1. Outlet bore to the engine oil providing system
2. Inlet bore from the oil pump to the oil filter
2. Install a NEW O-ring on oil filter cover.
3. Install the filter into the cover.
4. Apply engine oil on O-ring and on end of filter.
vmr2006-008-001_a
1. Slightly oil
2. Slightly oil
5. Install the cover on the engine.
6. Tighten oil filter cover screws to recommended
torque.
OIL FILTER COVER SCREWS
Tightening Torque
7. Reinstall remaining parts if applicable.
10 N•m ± 1 N•m
(89 lbf•in ± 9 lbf•in)
7