BRP Can-Am Outlander 2015 Series Manual page 232

vmr2006-044-025_a
1. Plain bearing
2. Oil bore
A. Measure plain bearing inside diameter
MAIN BEARING INSIDE DIAMETER (PTO/MAG)
SERVICE LIMIT
Plain Bearing Replacement (Main)
Plain Bearing Removal
NOTICE
Always properly support crankcase
halves when removing plain bearings. Dam-
age to crankcase halves may occur if this pro-
cedure is not performed correctly.
NOTE: Always use a press for removal of plain
bearings.
Carefully press the plain bearings out from the
crankcase half from the inside towards the out-
side.
NOTE: Place an appropriate support under
crankcase halves before removing plain bear-
ings.
REQUIRED TOOLS
CRANKCASE SUPPORT MAG/PTO
(P/N 529 036 031)
PLAIN BEARING
REMOVER/INSTALLER
(P/N 529 035 917)
NOTE: During disassembly, make sure not to
damage the sealing surfaces of the crankcase
halves.
vmr2012-017
42.100 mm (1.6575 in)
Subsection XX (BOTTOM END)
tmr2011-014-025_a
PRESS PLAIN BEARINGS OUTSIDE
1. Crankcase half
2. Plain bearing remover/installer
3. Crankcase support sleeve (P/N 529 036 031)
Plain Bearing Installation (Main)
NOTICE
Unless otherwise instructed, never
use a hammer to install plain bearings. Aways
use a press.
During reassembly, make sure not to damage the
sealing surfaces of the crankcase halves.
NOTE: Place the proper crankcase support sleeve
under crankcase halves before installing the plain
PLAIN BEARING REMOVAL
bearings, refer to
PROCEDURE
in this subsection.
Install plain bearings in a cold crankcase.
NOTE: Do not lubricate plain bearings and/or
crankcase for installation.
REQUIRED TOOL
PLAIN BEARING
REMOVER/INSTALLER
(P/N 529 035 917)
NOTE: Use an O-ring (Ø 42 x 1 mm to 1.5 mm
(.04 in to .06 in) thickness) to hold plain bear-
ings in place during installation. The O-ring will
disappear in the groove of the plain bearing re-
mover/installer.
1. Mark position of plain bearing oil bore on plain
bearing remover/installer.
2. Mark position of oil bore on crankcase half.
3. Align mark on plain bearing remover/installer
with mark on crankcase half.
15