BRP Can-Am Outlander 2015 Series Manual page 180

Subsection XX (INTAKE MANIFOLD)
PROCEDURES
INTAKE MANIFOLD
Intake Manifold Access
BODY
Refer to and remove the RH side panel.
Intake Manifold Removal
1. Release fuel pressure. Refer to
AND FUEL PUMP subsection.
2. Remove shift rod nut.
vmr2012-015-006_a
1. Remove nut
3. Disconnect the fuel hoses at the fuel injectors,
ELECTRONIC FUEL INJECTION (EFI).
refer to
CAUTION The fuel hose may still be un-
der pressure.
4. Disconnect fuel injector electrical connectors.
5. Disconnect MAPTS connector.
6. Pull off throttle body from intake manifold and
air intake silencer. Refer to
INJECTION (EFI)
.
NOTE: Do not disconnect throttle cable need-
lessly.
7. Remove wiring harness support from engine.
2
FUEL TANK
ELECTRONIC FUEL
vmr2012-015-005_a
1. Remove
8. Remove intake manifold from engine.
vmr2012-015-007_a
1. Remove
Intake Manifold Inspection
Check intake manifold for cracks, warping at
flanges or any other damage. Replace if neces-
sary.
Intake Manifold Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
Tighten intake manifold retaining screws to spec-
ified torque one cylinder at a time.
INTAKE MANIFOLD RETAINING SCREWS
Tightening Torque
Enable fuel pump using B.U.D.S.
20 N•m ± 2 N•m
(15 lbf•ft ± 1 lbf•ft)
vmr2013-015