BRP Can-Am Outlander 2015 Series Manual page 578

vmr2012-033-001_a
TYPICAL - OUTLANDER MODELS
1. Dash board support
All Models (Without a DPS)
4. Remove the air intake silencer. Refer to
TAKE SYSTEM
subsection.
5. Remove handlebar, refer to
MOVAL
in this subsection. Also remove locking
ties and separate wiring harnesses and hoses
from the steering column.
6. Disconnect the tie-rods from the pitman arm at
the bottom of the steering column. Refer to
TIE-ROD , further in this section.
vmr2012-039-008_a
TYPICAL
1. Steering column
2. Pitman arm
3. Tie-rod end
4. Cotter pin
5. Tie-rod retaining nut
NOTE: When removing tie-rods from pitman arm,
take note of positions of flat washers for installa-
tion.
7. Remove lower half bushing retaining bolts and
pull retainer off of half bushings.
vmr2013-039
TYPICAL
1. Lower retainer mounting screws (2)
2. Lower half bushing retainer
3. Steering column
4. Pitman arm
AIR IN-
8. Remove upper half bushing retaining bolts and
HANDLEBAR RE-
TYPICAL
1. Upper steering column support
2. Half bushings
3. Half bushing retainer
4. Retainer mounting screws (2)
9. Pull steering column from vehicle.
Steering Column Removal (With a
DPS)
1. Remove gauge support, refer to
2. Remove the front body module, refer to
Outlander Models
3. Remove dash board support.
Subsection XX (STEERING SYSTEM)
vmr2012-039-009_a
pull retainer off of half bushings.
vmr2012-039-010_a
GAUGE AND ACCESSORIES
subsection.
LIGHTS,
subsection.
BODY
11