BRP Can-Am Outlander 2015 Series Manual page 244

Subsection XX (CONTINUOUSLY VARIABLE TRANSMISSION (CVT))
GENERAL
NOTE: For a better understanding, the following
illustrations are taken with engine out of vehicle.
To perform the following instructions, it is not nec-
essary to remove engine.
WARNING
Never touch CVT while engine is running.
Never drive vehicle when CVT cover is re-
moved.
WARNING
Any drive pulley repairs must be performed
by an authorized Can-Am dealer. Subcompo-
nent installation and assembly tolerances re-
quire strict adherence to procedures detailed.
WARNING
The clutch assembly is a precisely balanced
unit. Never replace parts with used parts
from another clutch assembly.
PROCEDURES
CVT COVER
CVT Cover Access
Remove LH footrest panel, refer to
tion.
CVT Cover Draining
If water is present in CVT cover, it can be drained
as follows:
1. Remove drain reservoir from CVT cover.
Vmr2012-018-003_b
1. Drain reservoir
2. Spring clip
2. Let water drain from CVT cover.
4
3. Reinstall drain reservoir.
NOTICE
any debris entered the CVT cover, CVT must be
cleaned and inspected.
CVT Cover Removal
Remove CVT cover screws.
NOTE: Do not use and impact tool to remove CVT
cover screws. To support the CVT cover remove
the top center screw last.
Remove the CVT cover and its gasket.
Vmr2012-018-004_a
1. CVT cover screw
2. CVT cover
3. Gasket
BODY
subsec-
CVT Cover Installation
Install the top center screw of first.
NOTE: Do not use and impact tool to install CVT
cover screws.
Tighten the CVT cover screws as per following se-
quence.
Vmr2012-018-003_a
CVT COVER TIGHTENING SEQUENCE
If an appreciable amount of water or
vmr2013-019