BRP Can-Am Outlander 2015 Series Manual page 382

FAULT REPORTING
CODE MODULE
U0073 DPS
U0073 ECM
U0100 DPS
U0155
DPS
vmr2013-026
Subsection XX (DIAGNOSTIC SYSTEM AND FAULT CODES)
DESCRIPTION
CAN bus off, no Damaged circuit wires
or damaged DPS pins.
messages
Damaged circuit wires
CAN bus off, no
or damaged CLUSTER
messages
pins.
Damaged circuit wires,
Lost communication
damaged ECM or
with ECM (lost of CAN
damaged DPS/ECM
ID's)
pins.
Missing CAN ID.
Module internal error.
Lost communication
Damaged circuit wires
with CLUSTER
or damaged module
pins.
POSSIBLE CAUSE
Disconnect MPI2
from DLC connector.
Measure resistance between
DLC-1 and DLC-2. (Expected
value = 50 to 70 ohms).
Measure resistance between
DLC-1 and DPS1-C.
(Expected value < 2 ohms).
Measure resistance between DLC-2
and DPS1-D. (Expected value
< 2 ohms).
Disconnect MPI2
from DB connector.
Measure resistance between
DB-1 and DB-2. (Expected
value = 50 to 70 ohms).
Measure resistance
between DB-1 and ECM-B1.
(Expected value < 2 ohms).
Measure resistance between DB-2
and ECM-C1. (Expected value
< 2 ohms).
Disconnect MPI2
from DLC connector.
Measure resistance between
DLC-1 and DLC-2. (Expected
value = 50 to 70 ohms).
Measure resistance between
DLC-1 and ECM B1.
(Expected value < 2 ohms).
Measure resistance between DLC-2
and ECM C1. (Expected value
< 2 ohms).
Measure voltage between harness
connector CL-17 and ground.
(Expected value = 11 to 13 volts).
Disconnect MPI2
from DLC connector.
Measure resistance between
DLC-1 and DLC-2. (Expected
value = 50 to 70 ohms).
Measure resistance
between DLC-1 and CL-4.
(Expected value < 2 ohms).
Measure resistance between
DLC-2 and CL-19. (Expected value
< 2 ohms).
SERVICE ACTION
25