BRP Can-Am Outlander 2015 Series Manual page 292

Subsection XX (GEARBOX AND 4X4 COUPLING UNIT (500/650/800R))
If all switches are removed, make sure to put the
wires back in the right location.
vmr2012-019-004_a
1. Indicator switches
2. BROWN/GREY wire
3. WHITE/RED wire
4. ORANGE/GREY wire
4WD INDICATOR SWITCH
4WD Indicator Switch Access
To reach the 4WD indicator switch, refer to
and remove the following parts:
– Seat
– Console
– RH side panel
– RH engine panel (Renegade only).
4WD Indicator Switch Removal
Disconnect 4WD indicator switch connector from
engine wiring harness.
6
vmr2012-019-005_a
1. 4WD indicator switch
2. BLACK/BEIGE wire for contact to 4WD
3. Actuator
4WD Indicator Switch Test
Measure switch resistance as follows.
SWITCH
POSITION
2WD
BODY
If the resistance is out of specification, replace the
4WD indicator switch.
4WD Indicator Switch Installation
For installation, reverse the removal procedure.
Pay attention to the following details.
Take care do not damage indicator switch threads
during installation.
Apply carefully some
on threads of indicator switch.
081)
NOTICE
Do not apply Loctite 5910 on switch
plunger, as it will lead to switch malfunction.
GEARBOX OIL SEALS
Gearbox Oil Seals Replacement
Replace oil seals if they are brittle, hard or dam-
aged.
A small flat screwdriver can be used to remove
most of these oil seals.
NOTICE
Avoid scoring parts during oil seal
removal.
SWITCH WIRE RESISTANCE
BLACK/ Engine
Infinite (0L)
ground
BEIGE
LOCTITE 5910 (P/N 293 800
vmr2012-019