BRP Can-Am Outlander 2015 Series Manual page 368

FAULT REPORTING
CODE MODULE
P0112 ECM
P0113 ECM
P0114 ECM
vmr2013-026
Subsection XX (DIAGNOSTIC SYSTEM AND FAULT CODES)
DESCRIPTION
Damaged sensor,
damaged circuit wires,
Intake air temperature damaged connector or
sensor 1 circuit low damaged ECM pins,
ECM voltage supply
low
Damaged sensor, wires
Intake air temperature shorted to battery +,
sensor 1 circuit high ECM voltage supply
too high.
Damaged sensor,
damaged circuit wires,
Intake air temperature
damaged connector or
sensor Intermittent
damaged ECM pins,
ECM voltage supply.
POSSIBLE CAUSE
Make sure sensor
connector is fully inserted.
Measure voltage between
harness connector pins 1 and 3.
(Expected value: 4.8 to 5.1 volts).
Measure resistance from
connector: ECM-F3 to MAPTS-2.
(Expected value: < 2 ohms).
Measure resistance from
connector: ECM-A1 to MAPTS-3.
(Expected value: < 2 ohms).
Measure resistance from
connector: ECM-G2 to MAPTS-1.
(Expected value: < 2 ohms).
Measure resistance from connector:
ECM-F2 to MAPTS-4. (Expected
value: < 2 ohms).
Make sure sensor
connector is fully inserted.
Measure voltage between harness
connector pins 1 and 3. (Expected
value: 4.8 to 5.1 volt < 2 ohms volts).
Measure resistance from
connector: ECM-F3 to MAPTS-2.
(Expected value: < 2 ohms).
Measure resistance from
connector: ECM-A1 to MAPTS-3.
(Expected value: < 2 ohms).
Measure resistance from
connector: ECM-G2 to MAPTS-1.
(Expected value: < 2 ohms).
Measure resistance from connector:
ECM-F2 to MAPTS-4. (Expected
value: < 2 ohms).
Make sure sensor
connector is fully inserted.
Measure voltage between
harness connector pins 1 and 3.
(Expected value: 4.8 to 5.1 volts).
Measure resistance from
connector: ECM-F3 to MAPTS-2.
(Expected value: < 2 ohms).
Measure resistance from
connector: ECM-A1 to MAPTS-3.
(Expected value: < 2 ohms).
Measure resistance from
connector: ECM-G2 to MAPTS-1.
(Expected value: < 2 ohms).
Measure resistance from connector:
ECM-F2 to MAPTS-4. (Expected
value: < 2 ohms).
SERVICE ACTION
11