BRP Can-Am Outlander 2015 Series Manual page 81

Subsection 03 (PERIODIC MAINTENANCE PROCEDURES)
Front Differential Oil Replacement
1. Place vehicle on a level surface. Set transmis-
sion in park position.
2. Place a drain pan under the front differential.
3. Remove drain plug.
4. Remove filler plug.
vmr2012-036-001_a
RH SIDE OF VEHICLE
1. Filler plug
2. Drain plug
5. Lift LH side of vehicle to completely drain front
differential.
NOTE: Allow enough time for oil to flow out.
6. Lower vehicle on the ground.
7. Install and tighten drain plug to specification.
DRAIN PLUG
Tightening torque
8. Refill front differential with recommended oil.
CAPACITY
500 ml (17 U.S. oz)
75W 90 (API GL-5) gear oil
9. Reinstall filler plug with a NEW sealing ring.
10. Tighten filler plug to specification.
FILLER PLUG
Gasket
Tightening torque
Rear Final Drive Oil Level Verification
1. Ensure vehicle is on a level surface.
18
7.5 N•m ± 0.5 N•m
(66 lbf•in ± 4 lbf•in)
RECOMMENDED OIL
XPS SYNTHETIC
GEAR OIL (75W 90)
(P/N 293 600 043) or a
NEW
22.5 N•m ± 2.5 N•m
(17 lbf•ft ± 2 lbf•ft)
2. Clean filler plug area.
3. Remove filler plug.
vmr2013-056-200_b
LH REAR SIDE OF VEHICLE
1. Filler plug
4. Verify the oil level.
650 model
Insert a wire with a 90° bend through the oil filler
hole.
Oil level must be within the following specification
from the bottom of oil filler hole.
OIL LEVEL
20 mm ± 5 mm (9/16 in ± 3/16 in)
1000 model
Oil level must reach the lower edge of the oil filler
hole.
5. Reinstall filler plug with a NEW sealing ring.
FILLER PLUG
Gasket
Tightening torque
Rear Final Drive Oil Replacement
1. Ensure vehicle is on a level surface.
2. Clean filler and drain plug areas.
3. Place a drain pan under rear final drive.
4. Unscrew filler plug.
5. Remove drain plug.
NEW
22.5 N•m ± 2.5 N•m
(17 lbf•ft ± 2 lbf•ft)
vmr2013-056